Canon VB-C500D Operation Manual page 75

(8)[Details]
When this check box is selected, you can enter [Sensitivity], [Size] and [Duration] values.
If the check box is not selected, [Duration (sec.)] is fixed to [0.2].
Tip
Even when a change has occurred in the image shown inside the viewer's motion detection
area frame, the camera will not recognize it as [Motion] if the [Sensitivity] setting is low.
Even when the sensitivity is raised, the camera mode will not change to [Detected] unless
the part of the area frame that has moved meets the [Size] and [Duration] settings for
motion.
You can also select the setting area by clicking a desired motion detection area frame in
the viewer. The selected detection area frame is shown by blue solid lines.
By setting the Selected areta to [Not specified], you can show the detection statuses for all
motion detection areas at once. Clicking a point in the viewer where no area frame is set
has the same effect.
4. Check the motion detection status of the camera.
To check the level of motion detection operation based on the specified settings, select the
[Display motion detection status of the camera] check box. The motion detection status will be
shown by the icons specified below.
If the [Display motion detection status of the camera] check box is selected, the settings
cannot be selected. To save the settings, clear this check box.
[Detection disabled]
[Detected]
[Not detected]
Note
If a proxy server is used, the video frame rate may drop depending on the proxy load.
Accordingly, it is recommended that you don't connect the camera via a proxy while this
function is set.
It is recommended that the motion detection level be set in a condition as close as possible
to the condition in which the camera is actually used.
Motion Detection Setting Tool
2-13