Configure Port-Based Vlans - D-Link DES-3624 Series User Manual

Stackable NWay Ethernet Switch User's Guide
♦ Action Select the desired action by toggling between Add and Remove.
♦ MAC Address The MAC address of the broadcast domain member being added or removed.
Please note that the Status field for the MAC address you have entered may read Not-Apply. Once the Switch
is restarted in MAC-based broadcast domain mode, the MAC-addresses will be applied, meaning that the
broadcast domain is active.
Current Broadcast Domain, Number of members, MAC Address (in the lower part of the screen), and Status
reflect the current conditions. They are read-only fields and cannot be changed.

Configure Port-based VLANs

Choose Configure Port-based VLANs on the VLAN Configuration screen (System Configuration
Configure VLANs & MAC-based Broadcast Domains) to access the Port-based VLAN Configuration
menu pictured below (note that if you have just changed to this mode, you must also reboot the Switch before
being able to work with port-based VLANs):
Figure 6-33. Port-based VLAN Configuration menu
The field you can set is:
♦ Management Vlan ID Enter a VLAN ID (VID) from 1 to 12 for use with management packets.
Select Configure Port-based VLAN Entry at the bottom of the menu above to access the following screen:
74 Using the Console Interface