Edge Blending Adjustment - Panasonic DLP PT-D12000E Operating Instructions Manual

How to use ADVANCED MENU (continued)
2. Press ENTER.
• The "CLAMP POSITION" screen will be
displayed.
CLAMP POSITION
POSITION
ADJUST
Press ◄► to adjust.
3.
• The value changes from 0 to 255.
• The optimal value for the clamp position
adjustment
If dark areas are crushed:
The optimal value is the point where the dark
area is best improved.
If the dark areas are displayed in green:
The optimal value is the point where the green
areas become black and the crushing effect is
rectified.
Note
• The clamp position can be adjusted only when the
RGB signal input is applied with RGB1 and RGB2 IN.

Edge blending adjustment

This projector has the function to hide the seams for
multi-screens.
Press ▲▼ to select "EDGE
1.
BLENDING".
CLAMP POSITION
EDGE BLENDING
FRAME DELAY
Press ◄► to switch "EDGE
2.
BLENDING".
• The setting will change as follows each time
◄► is pressed.
OFF
• OFF:
When the multi-screens are not going to be used.
• ON:
When the tilting inside the unit is to be used for the
tilting of the edge blending area.
• USER:
When a specific tilting is to be used for the tilting
of the edge blending area. (Separate software is
required to establish these settings. Consult your
dealer.)
3. Press ENTER.
• The "EDGE BLENDING" screen will be
displayed.
EDGE BLENDING
UPPER
START
66 – ENGLISH
1
OFF
DEFAULT
ON USER
ON
0
Press ▲▼ to specify the area to
4.
be adjusted.
• To joint the top: set "UPPER" to "ON".
• To joint the bottom
• To joint the left: set "LEFT" to "ON".
• To joint the right:
Press ◄► to toggle "ON" and
5.
"OFF".
Press ◄► to adjust the
6.
compensation width and start
position.
To display the adjustment
marker
Press ▲▼ to select "MARKER".
7.
RIGHT
MARKER
BRIGHT ADJUST
Press ◄► to select "ON".
8.
• A marker for adjusting the picture position
appears. The optimal point is the position
where the red line of one frame overlaps the
green line of the other frame.
The correction widths of the jointed frames
must be the same value all the time. The
optimal joint cannot be achieved if the jointed
frames have different correction widths.
The optimal point is where
these lines overlap.
Green line
Red line
Press ▲▼ to select "BRIGHT
9.
ADJUST".
RIGHT
MARKER
BRIGHT ADJUST
: set "LOWER" to "ON".
set "RIGHT" to "ON".
OFF
OFF
OFF
OFF