Option2 Settings - Panasonic PT-D10000 Operating Instructions Manual

Option2 settings

MENU
This menu can be used to make a variety of
picture and projector settings.
MENU MENU
Press to display the Press to display the
MAIN MENU screen. MAIN MENU screen.
Press to select Press to select
"OPTION2". "OPTION2".
Press to display the Press to display the
"OPTION2" menu. "OPTION2" menu.
MAIN MENU MAIN MENU
PICTURE PICTURE
POSITION POSITION
ADVANCED MENU ADVANCED MENU
DISPLAY LANGUAGE DISPLAY LANGUAGE
OPTION1 OPTION1
OPTION2 OPTION2
TEST PATTERN TEST PATTERN
SIGNAL LIST SIGNAL LIST
NETWORK NETWORK
SECURITY SECURITY
MENU SELECT MENU SELECT
SUB MENU SUB MENU
ENTER ENTER
Setting a projector ID
The projector has an ID number setting function that
helps the user to control two or more projectors either
simultaneously or separately with a single remote
control. The ID number is set to "ALL" by default.
Hence the ID number need not be set when only
one projector is used.
1. Press ▲▼ to select
▲▼◄►
"PROJECTOR ID".
ENTER
OPTION2 OPTION2
PROJECTOR ID PROJECTOR ID
INSTALLATION INSTALLATION
ALTITUDE ALTITUDE
DIRECTION DIRECTION
LAMP SELECT LAMP SELECT
LAMP RELAY LAMP RELAY
RS-232C RS-232C
SYSTEM INFORMATION SYSTEM INFORMATION
AIR FILTER CLEANING AIR FILTER CLEANING
DATE AND TIME DATE AND TIME
STARTUP LOGO STARTUP LOGO
DEFAULT
PASSWORD PASSWORD
2. Press ◄► to switch
"PROJECTOR ID".
• The setting will change as follows each time
◄► is pressed.
3. Press MENU twice.
• This concludes the setting procedure and the
on-screen indications disappear and the normal
screen appears again.
Note
• The ID number can be set to "ALL", or selected from
"1" to "64".
• If the projectors are given ID numbers, their remote
controls must be assigned the same ID numbers,
respectively.
• If the ID number of a projector is set to "ALL", it can
be controlled by the remote control or the PC with
any ID number.
If multiple projectors are used and some of
them have their IDs set to "ALL", they cannot be
controlled separately from the projectors with other
ID numbers. For details on remote control ID setting,
see page 18.
2 2
FRONT-F FRONT-F
LOW LOW
H H
QUAD QUAD
OFF OFF
LOGO1 LOGO1
MENU SELECT MENU SELECT
CHANGE CHANGE
ALL
64
1
2
75
ENGLISH –