Communication Conditions - Panasonic PT-D10000 Operating Instructions Manual

Lamp relay
If using the projector for a continuous period of
24 hours or more, this setting can be used to
automatically switch the lamps that are turned on in
order to reduce the lamp deterioration that can occur
as a result of continuous use.
1. Press ▲▼ to select "LAMP
RELAY".
OPTION2 OPTION2
PROJECTOR ID PROJECTOR ID
INSTALLATION INSTALLATION
ALTITUDE ALTITUDE
DIRECTION DIRECTION
LAMP SELECT LAMP SELECT
LAMP RELAY LAMP RELAY
RS-232C RS-232C
SYSTEM INFORMATION SYSTEM INFORMATION
AIR FILTER CLEANING AIR FILTER CLEANING
DATE AND TIME DATE AND TIME
STARTUP LOGO STARTUP LOGO
PASSWORD PASSWORD
MENU SELECT MENU SELECT
CHANGE CHANGE
2. Press ◄► to switch "LAMP
RELAY".
• The time interval for lamps to be switched will
change as shown in the diagram below each
time ◄► is pressed.
OFF
23:00
Note
• When "SINGLE", "DUAL" or "TRIPLE" is selected as
the "LAMP SELECT" setting, the lamps will switch
in accordance with the setting time. If "QUAD" is
selected, three lamps will illuminate for 8 hours after
the specified time.
• The setting time will be the local time. (p. 81)
2 2
FRONT-F FRONT-F
LOW LOW
H H
QUAD QUAD
OFF OFF
LOGO1 LOGO1
00:00
01:00
RS-232C setting
This sets communication parameters for the projector.
1. Press ▲▼ to select "RS-232C".
OPTION2 OPTION2
PROJECTOR ID PROJECTOR ID
INSTALLATION INSTALLATION
ALTITUDE ALTITUDE
DIRECTION DIRECTION
LAMP SELECT LAMP SELECT
LAMP RELAY LAMP RELAY
RS-232C RS-232C
SYSTEM INFORMATION SYSTEM INFORMATION
AIR FILTER CLEANING AIR FILTER CLEANING
DATE AND TIME DATE AND TIME
STARTUP LOGO STARTUP LOGO
PASSWORD PASSWORD
MENU SELECT MENU SELECT
SUB MENU SUB MENU
ENTER ENTER
2. Press ENTER.
• The "RS-232C" screen will be displayed.
RS-232C RS-232C
SERIAL IN SERIAL IN
(IN) BAUDRATE (IN) BAUDRATE
(IN) PARITY (IN) PARITY
(OUT) BAUDRATE (OUT) BAUDRATE
(OUT) PARITY (OUT) PARITY
VPS SYSTEM VPS SYSTEM
GROUP GROUP
MENU SELECT MENU SELECT
CHANGE CHANGE
3. Press ▲▼ to select "SERIAL
IN".
4. Press ◄► to switch "SERIAL
IN".
• The setting will change as follows each time
◄► is pressed.
RS-232C
5. Press ▲▼ to select

communication conditions.

6. Press ◄► to confirm the setting.
7. Press MENU three times.
• The on-screen indications disappear, and the
system returns to the normal screen.
2 2
FRONT-F FRONT-F
LOW LOW
H H
QUAD QUAD
OFF OFF
LOGO1 LOGO1
RS-232C RS-232C
38400 38400
EVEN EVEN
38400 38400
EVEN EVEN
MASTER MASTER
A A
MASTER MASTER
RS-422
ENGLISH –
79