Table of Contents
Advertisement
Setting up the IPv6 Router, your PC, and this Product
Setting up the IPv6 Router
Set up the router as you subscribe to the IPv6 service. If the access from WAN side
is disabled on the router, enable the TCP packets from WAN side in the packet
filtering.
Setting up your PC
1.
Click [Start]
•
Command Prompt window is displayed.
2.
Enter "ipv6 install".
•
"Succeeded" is displayed.
Notes
•
If Windows XP Service Pack 1 or later is not installed, "Succeeded" will
not be displayed. Install it on your PC.
•
When you use Windows XP Service Pack 2, click [Start]
Panel]
tab
check [Allow incoming router request] check box in the ICMP Settings
window.
3.
Enter "ipconfig".
•
If the IPv6 address is properly assigned to your PC, IPv6 address will be
displayed on the window.
Setting up this Product
Usually, IPv6 address is automatically assigned. If you assign a static IPv6
address, see page 41. To access this product in IPv6, you need to subscribe to the
domain name service such as Viewnetcam.com, and register the URL.
Confirming that You Can Access this Product
Confirm that the image is properly displayed (see page 12).
[All Programs]
[Security Center]
[Settings] button of ICMP in the Windows Firewall window, then
[For assistance, please call: 1-800-272-7033]
[Accessories]
[Command Prompt].
[Windows Firewall]
Operating Instructions
[Control
[Advanced]
15
Advertisement
Table of Contents
