Adjusting Bass And Treble; Adjusting Loudness; Using Subwoofer Output; Using Non Fading Output - Pioneer AVIC-N3 Operation Manual

Adjusting bass and treble

Use this function to adjust the bass and treble.
The ability to select the frequency as well as the
level gives you good control over the tonal bal-
ance of the audio.
The bass and treble adjust screens allow you to
reduce or boost frequencies in the following area;
Bass - 40, 63, 100, 160 (Hz)
Treble - 2.5K, 4K, 6.3K, 10K (Hz)
❒ If EQ-EX is turned on and CUSTOM is
selected as the equalizer curve, you can
adjust bass and treble settings.
➲ Compensating for equalizer curves (EQ-EX)
➞ Page 110
1
Touch "BASS" or "TREBLE" in the
AUDIO menu.
2
Touch  or  to select the desired fre-
quency.
3
Touch "+" or "–" to adjust the bass or tre-
ble level.
Each time you touch "+" or "–" increases or
decreases the bass or treble level. +6 to –6 is
displayed as the level is increased or
decreased.

Adjusting loudness

Loudness compensates for deficiencies in the
low- and high-sound ranges at low volume.
1
Touch "LOUDNESS" in the AUDIO menu.
2
Touch "ON" to turn loudness on.
To turn loudness off, touch "OFF".
3
Touch  or  to select a desired level.
Each time you touch  or  selects level in
the following order:
LOW — MID — HIGH

Using subwoofer output

The navigation system is equipped with a sub-
woofer output which can be turned on or off.
❒ When the subwoofer output is on, you can
adjust the cut-off frequency and the output
level, and the phase of the subwoofer.
1
Touch "SUB WOOFER" in the AUDIO
menu.
When PREOUT (the subwoofer controller
setting in INITIAL menu) is FULL, you can-
not select "SUB WOOFER".
➲ Setting the rear output and subwoofer con-
troller ➞ Page 113
2
Touch "ON" to turn subwoofer output on.
To turn subwoofer output off, touch "OFF".
3
Touch "REVERSE" or "NORMAL" to
select the phase of subwoofer output.
4
Touch "+" or "–" to adjust the output
level of the subwoofer.
+6 to –6 is displayed as the level is increased
or decreased.
5
Touch  or  to select cut-off frequency.
Each time you touch  or  selects cut-off fre-
quencies in the following order:
50 — 80 — 125 (Hz)
Only frequencies lower than those in the
selected range are output from the subwoofer.

Using non fading output

When the non fading output setting is on, the
audio signal does not pass through navigation
system's low pass filter (for the subwoofer), but is
output through the RCA output.
1
Touch "NON FADING" in the AUDIO
menu.
Only when PREOUT (the subwoofer control-
ler setting in INITIAL menu) is FULL, you
can select "NON FADING".
➲ Setting the rear output and subwoofer con-
troller ➞ Page 113
2
Touch "ON" to turn non fading output on.
To turn non fading output off, touch "OFF".
3
Touch "+" or "–" to adjust the output
level of the non fading.
+6 to –6 is displayed as the level is increased
or decreased.
109