Pioneer AVIC-N3 Operation Manual page 142

Message
Speed pulse wire is not connected.
System will start to learn without
speed pulse. Please keep in mind
that accuracy is not fully ensured
without speed pulse.
Vibration is detected. Please power
off the system and check the installa-
tion. After you have checked, please
re-boot the system and press "OK".
Direction of G sensor is not correct.
Please power off the system and
check the installation. After you have
checked, please re-boot the system
and press "OK".
Gyro Sensor is not working properly.
Please consult your dealer or Pioneer
service center.
This function is not available now.
System detected that the vertical
angle of the installation has been
changed. Learning status for Gyro
Sensor has been initialized.
System detected that the vertical
angle of the installation exceeds the
permission level. Please install the
navigation unit correctly.
No data available at this time.
No XM signal. Please wait.
XM updating. Please wait.
UPDATING
140
When
The speed signal input (pink lead
wire) of the power cable is not con-
nected.
The navigation system is installed in
a place where it may be affected by a
large vibration.
Direction of G sensor is set incor-
rectly.
Abnormal output of Gyrosensor is
detected.
The screen cannot be displayed with
Vehicle Dynamics Display.
Because the sensor has not been
taught so the sensor information
cannot be acquired.
If the mounting angle of the Hide-
away unit has been changed.
The navigation system is installed
with an extreme angle exceeding the
limitation of the installation angle.
If no data is available that can be
used with the XM tuner.
While waiting for a response from
the XM tuner.
You are in an area that cannot
receive XM tuner reception.
Your current location provides very
poor reception.
Service subscription is either
XM audio only or XM NavTraffic
stand alone.
Radio is being updated with the lat-
est encryption code.
The selected channel is not included
in your subscription.
Radio is being updated with the lat-
est encryption code.
What to do
To operate with 3D hybrid mode, con-
nect the speed signal input (pink
lead wire) of the power cable cor-
rectly.
Although it can be operated with
Simple hybrid mode without con-
necting the speed signal input, the
precision of the positioning will be
less accurate.
Re-install the Hide-away unit in a
place where the unit will not be
affected by vibration.
See the "Installation Manual" and set
the direction of the Hide-away unit
correctly.
Note down the error code shown on
the screen; turn off the power, and
then contact your nearest Pioneer
service facility.
If the sensor learning status reaches
the Sensor Initializing status or more,
the system is ready to be used.
The system initializes the sensor in
order to operate it with the maximum
performance and automatically
starts re-learning.
Confirm the installation angle. (The
navigation system must be installed
within the allowed installation angle.
For details, refer to "Installation Man-
ual".)
Wait for a while and try the operation
again.
Wait for a while and try the operation
again.
Move into an area that can receive
XM tuner reception.
Change your location.
Since the GEX-P10XMT is capable of
receiving both XM audio and XM
NavTraffic service, if you are sub-
scribed to only one or the other, the
system checks to see if you have
added another service to your
account since you last powered on
the navigation system. When you
subscribe to both services, this mes-
sage will stop appearing when you
turn the ignition ON (ACC ON).
Wait until the encryption code is fully
updated.
Select another channel.
Wait until the encryption code is fully
updated.