Replacing The Palm Rest; Smartcard Assembly; Removing The Smartcard Assembly - Dell LATITUDE E6400 XFR Service Manual

23.2 Replacing the Palm Rest

CAUTION: Before you begin any of the procedures in this section, follow the safety
instructions that shipped with your computer.
NOTE: If this is a new palm rest, remove the two cable access panels, and the keyboard cover
before installation.
1. Align the palm rest on the base assembly.
2. Replace the 16 M2.5 x 8-mm screws on the top of the palm rest.
3. Tighten the one captive screw on the top of the palm rest.
4. Connect the contactless smartcard cable, the LED board, the touchpad cable, and the Finger print reader cable
(optional) to the system board.
5. Replace the LED board access panels and secure each with four M2.5 x 5-mm screws.
6. Replace the keyboard (see Replacing the Keyboard).
7. Replace the display assembly (see Replacing the Display Assembly).
8. Follow the procedures in After Working on Your Computer.

24 Smartcard Assembly

24.1 Removing the Smartcard Assembly

CAUTION: Before you begin any of the procedures in this section, follow the safety
instructions that shipped with your computer.
1. Follow the procedures in Before Working on Your Computer.
2. Remove the palm rest (see Removing the Palm rest).
3. Remove the hard drive (see Removing the Hard Drive).
4. With the hard drive door open, carefully peel the smartcard gasket from the ceiling of the chamber opening.
Page 46
™
Dell Latitude™ E6420 XFR Service Manual