Installing The Power Supply; Power Supply Installation - NEC DSX-160 Hardware Manual

Installing the Power Supply

Power Supply Installation

The power supply provides the DC power sources required to operate the system.
To install a power supply:
1. Slide the power supply into the CN101 slot.
2. Using a long-shaft phillips head screwdriver, tighten the two screws that secure the power supply.
A DSX-160 may require up to 3 power supplies (depending on system configuration), using slots CN101,
CN102 and CN103. Refer to System Preparation (page 21) for more.
When installing multiple power supplies in DSX-160:
Install the first supply in slot CN10
1.
2. Install the second supply in slot CN10
3. Install the third supply in slot CN10
DSX-80/160 Hardware Manual
.
1
.
3
.
2
Figure 11: Installing the Power Supply
In case of fire, disconnect the power cord from the AC outlet.
Installing the Power Supply
Important
DSX-80 4-Slot KSU Shown
Installation ◆ 29