Table of Contents
Advertisement
Document Revision 1
___________________________________________________________________________________
S
3
F
ECTION
EATURES
3.1
S
4
S
ECTION
ETTING UP YOUR
Before installing the repeater, you need to activate the repeater mode on your base
and then register the repeater to the base and any handsets. Before you start the
registration process, be sure you have:
___________________________________________________________________________________
2 - 4
Automatic registration to the base
Up to six repeaters per base station
Up to three repeaters in a sequential or daisy-chain layout
Two internal antennas to support two simultaneous calls
Repeater connection verification tone
Low power consumption
Specifications
The following specifications apply to the NEC D
AC Power Adapter:
Frequency Band:
Transmit Power:
Receiver Sensitivity:
Standards:
R
EPEATER
A working base
A working handset registered to that base
Any repeaters you want to register to this base (you must complete the
registration process separately for each repeater)
At least one of the AC adapters supplied with the repeaters
Use ONLY the power adapter that came with your repeater. A different power
adapter may cause an electrical hazard or damage the repeater.
Input: 100 -240VAC 50 -60Hz (RJ-11)
Output: 5 V dc , 500 mA
1920MHz - 1930MHz
100mW
-3
<-91 dBm at 10
BER
Designed in accordance with the Digital Enhanced Cordless
Telecommunications (DECT) standard
Compliant with TBR6, TBR22 (Generic Access Profile, GAP),
and ETS 300 700 - ETSI Wireless Relay Station Specification
term
D
Cordless DECT
term
Cordless DECT repeater.
Getting to Know Your Repeater
Advertisement
Table of Contents
