NEC PX-TUAN-01 Manual page 11

If you receive more than one TV system, don't worry. The PX-TUAN-01 has intelligent TV system
detection software and will store each channel with the correct A/V settings during channel scan.
-7- Press Channel "+" or "-" key, or select a channel number from table in section 5.3 matching one of
your locally received TV channels, to check if all settings and connections are OK.
-8- Press "Menu" key and go via "SETTING UP" >> "CHANNEL" to >> "AUTOSCAN" menu.
If the PX-TUAN-01 is connected to a cable network, your cable operator might provide an
ACI (Automatic Channel Installation) signal on one of the TV channels.
In this case follow step 8.1 or 8.2.
If you are sure there is no ACI information on any of the received TV channels, e.g. when
PX-TUAN-01 connected to a roof antenna, follow step 8.3
-8.1- If you know on which TV channel the ACI information is available (most of the time the info
channel of the cable operator) select this TV channel with the help of the channel table in
section 5.3 and select "SCAN: ACI ON" and confirm with OK.
A "Warning" message will appear, confirm again with OK.
The PX-TUAN-01 will now immediately detect the ACI information and load this into the
CHANNEL TABLE. This will take less than 1 minute.
After a successful installation, the PX-TUAN-01 is programmed with all channels and channel
names according to the cable operator's provided ACI list!
No hassle, just plug and play.
-8.2- If you are not sure if your cable operator provides an ACI signal, or don't know the channel
number with the ACI information, select "SCAN:ACI ON" and confirm with OK (this can be
done on any channel). A "Warning" message will appear, confirm again with OK.
The PX-TUAN-01t will start to scan all channels and check on each channel if the ACI
information is available. If found, the result will be same as 8.1. , if not, the result will be same
as 8.3. It will take about 5 minutes to scan all frequencies. The display will keep you informed
about the number of channels that are already stored.
-8.3- If you are sure there is no ACI available (or you want to ignore the ACI information deliberately)
select "SCAN: ACI OFF" and confirm with OK. A "Warning" message will appear, confirm
again with OK. During scanning the intelligent Autoscan system of the PX-TUAN-01 will
decode for each received channel, the channel name transmitted in the Teletext information
(if available) and load it into the channel table.
It will take about 5 minutes to scan all frequencies.
To complete all channel names and put all channels into the right sequence please follow the
instructions in 4.2.3.2 and 4.2.3.3.
PX-TUAN-01 Instruction Manual
-11-