Product Overview; Rear View Of Main Body - NEC PX-TUAN-01 Manual

Chapter 2 Installation

2.1 Product Overview

2.1.1 Rear View of Main Body

Processed Video OUT
Y Cb Cr
Y Cb Cr
S-Video
①
POWER ON/OFF
Use the power switch to select power ON or OFF.
②
POWER IN
Connect one of the outputs of the supplied special power cable adapter (Y- type) to this
input. The other output of the power cable adapter should be connected to the display's
power input. The original power cord of the display should be connected to the input of the
power cable adapter.
③
IR Input
Connect the IR sensor connection cable to the IR input.
④
RF IN
Connect the RF coaxial cable from your Cable TV network or terrestrial antenna.
⑤
Monitor OUT – Video (unprocessed "raw" Video)
This output always provides the video picture from the actual tuned TV channel. It can be
used to monitor the TV picture irrespective of the mode of the processed video outputs.
This enables you to have a simultaneous display of TV picture and Teletext for use with
NEC Plasma Display models 50XR4 and 61XR3. This output signal is not controlled by the
video settings of the tuner's processed Video outputs but is processed solely through the
superior 3D Video decoder integrated in the NEC Monitor Display, resulting in an
outstanding TV picture.
⑥
Monitor OUT – Audio L+R
Provides always the L/R decoded audio signal from the tuner.
The Audio signal is not controlled by the Audio settings of the processed audio outputs.
L L
R R
Monitor OUT
PX-TUAN-01 Instruction Manual
L
R
-5-