Table of Contents
Advertisement
External Monitor
You can add a standard external monitor to your NEC Versa using a display signal
cable (usually provided with the monitor). One end of the cable must have a 15-pin
connector for the system.
Note
DDC-compliant monitor. Refer to the user's guide that ships with the monitor or check
with your supplier, to determine if your external monitor is DDC-compliant.
Follow these steps to connect an external monitor to your NEC Versa.
Check that the NEC Versa is powered off and the monitor power switch is turned
1.
off.
Open the left-most port cover on the back of the system and locate the monitor
2.
port.
Attach the 15-pin cable connector to the monitor port on the system. Secure the
3.
cable connection with the screws provided.
4.
Connect the monitor power cable and plug it into a properly grounded wall outlet.
Follow any setup instructions in the monitor's user's guide.
5.
Turn on power to the system and device.
6.
Press
7.
8-2 Using External Devices
For optimal performance when connecting an external monitor, use only a
Connecting a monitor
to toggle through the video modes.
Fn-F3
Advertisement
Table of Contents
