Using The Cmc Cli To Set The Ip Address; Using The Cmc Gui To Set The Ip Address - Dell M8428-K Hardware Reference Manual

Using the CMC CLI to set the IP address

Use the following steps to connect modify the converged network switch IP address through the
CMC CLI.
1. Establish a Telnet session to the CMC CLI.
2. At the command prompt, type connect switch-x where x is the bay where the switch module is
3. At the login prompt, enter the default user name as "admin" and password as "password".
4. Use the appropriate CLI commands to change the IP address of the selected switch module.

Using the CMC GUI to set the IP address

To change the IP address, use the following steps:
1. Click the I/O Module Overview in the navigation panel of the CMC menu.
2. Open the CMC application's Setup tab.
3. Enter the new information in the IP Address, Subnet Mask, and Gateway fields as appropriate
4. To enable DHCP, select DHCP Enabled and click Apply.
FIGURE 3
Dell M8428-k Hardware Reference Manual
53-1001980-01
installed. For example, switch-x can be:
•
Switch-3 for switch module installed in bay B1.
•
Switch-4 for switch module installed in bay B2.
•
Switch-5 for switch module installed in bay C1.
•
Switch-6 for switch module installed in bay C2.
Refer to your Blade Server Enclosure CLI documentation.
and click Apply.
CMC Setup Tab
Modifying the converged network switch IP address
2
11