Yamaha 01V96i Reference Manual page 95

2.
Press the DISPLAY ACCESS [DIO/SETUP] but-
ton repeatedly until the DIO/Setup |
MIDI/Host page appears.
1
3.
Move the cursor to the REMOTE parameter
1
box ( ) in the SPECIAL FUNCTIONS section,
rotate the Parameter wheel to select MIDI,
then press [ENTER].
If the MIDI port is already in use, a window confirming
the assignment change appears. Move the cursor to the
YES button, then press [ENTER].
Tip: If the REMOTE parameter box is grayed out, proceed to
Steps 4 and 5 to set the TARGET parameter, then return to
Steps 2 and 3.
4.
Press the DISPLAY ACCESS [DIO/SETUP] but-
ton repeatedly until the DIO/Setup | Remote
page appears.
5.
Move the cursor to the TARGET parameter
box, rotate the Parameter wheel to select
USER DEFINED, then press [ENTER].
The confirmation window for changing the setting
appears. Move the cursor to the YES button, then press
[ENTER]. The display changes as follows:
4 1
5
6
2 3
MIDI Remote Layer
1
TRANSMIT ENABLE/DISABLE
This button switches the MIDI Remote function between
enable and disable.
2
INITIALIZE
This button resets the settings stored in the bank selected
by the BANK parameter their default settings.
3
BANK
This parameter enables you to select one of four banks.
4
ID, SHORT, LONG
These parameters display the channel names. The ID
parameter displays the channel ID (RM01–RM16) for the
currently-controlled MIDI device.
5
ON section
This section displays the type of MIDI messages (in hexa-
decimal or alphabet) assigned to the [ON] buttons for the
currently-selected channels (RM01–RM16).
• LATCH/UNLATCH
This button toggles between Latch and Unlatch for [ON]
button operation.
• LEARN
When you turn on this button, MIDI messages received
at the MIDI IN port are assigned to the DATA parameter
boxes.
• DATA parameter boxes
These boxes display the type of MIDI messages (in hexa-
decimal or alphabets) assigned to the [ON] button).
6
FADER section
This section displays the type of MIDI messages (in hexa-
decimal or alphabet) assigned to the faders for the cur-
rently-selected channels (RM01–RM16).
6.
Move the cursor to the desired bank button
(BANK parameter buttons 1–4), then press
[ENTER].
7.
Press the LAYER [REMOTE] button to select
Remote layer.
You can now use the MIDI Remote function.
8.
Use the faders and [ON] buttons to control
the MIDI device.
95
01V96i—Reference Manual