SPA9000 Field Reference
Voice tab
SPA9000 Voice System Administration Guide
FAX Tone Detect Mode:
Voice tab > FXS 1/2 page
FXS Port Polarity Configuration section
Idle Polarity
Caller Conn Polarity
Callee Conn Polarity
Voice tab >
Line 1/2/3/4 page
You can use the Line 1 - Line 4 pages to configure the line interfaces on your
SPA9000. The line interface page includes the following sections:
•
"Line Enable section," on page 252
•
"Network Settings section," on page 252
•
"SIP Settings section," on page 252
•
"Subscriber Information section," on page 255
•
"Dial Plan section," on page 256
•
"NAT Settings section," on page 256
•
"Proxy and Registration section," on page 257
The method of fax tone dection: caller and callee, caller only,
or callee only
Default: caller or callee
NOTE
This setting allows a fax tone to be detected from
either side of the call.
Polarity before a call is connected: Forward or Reverse.
Default: Forward
Polarity after an outbound call is connected: Forward or
Reverse.
Default: Forward
Polarity after an inbound call is connected: Forward or
Reverse.
Default: Forward
B
251