Connecting Twisted Pair Cable / Sfp Module / Sfp+ Module / Cx4 Cable - Fujitsu XG0224 Hardware Manual

Hardware guide
Hide thumbs Also See for XG0224:
Table of Contents

Advertisement

XG0224 Hardware Guide
2.3.3
Connecting Twisted Pair Cable / SFP Module / SFP+ Module
/ CX4 Cable
The following describes how to connect twisted pair cable, SFP module, SFP+ module, and CX4 cable.
Use straight cable when connecting with routers and terminals. Use crossing cable in case of cascading connection with
other switching HUBs with transmission mode at fixed setting other than auto negotiation.
Port of the switch is set auto negotiation enable by default.
(However, SFP+ Slots and CX4 port only support 10Gbps full duplex mode fixed setting.)
Ports automatically apply to the maximum speed that plugged equipment supports by the auto negotiation function.
10/100/1000BASE-T port
SFP slot
Connecting Twisted Pair Cable
Insert twisted pair cable to 10/100/1000BASE-T port until it clicks.
Precautions
• In case of 1000BASE-T, usable twisted pair cables are unshielded twisted pair cable (UTP) over category 5E and
shielded twisted pair cable (STP).
• RJ45 ports 21 through 24 are combination ports that are associated with the four SFP ports. Their use is mutually
exclusive. If the RJ45 port 21 is cabled then the associated SFP slot cannot be used.
• Discharge twisted pair cable before connecting as twisted pair cable may be charged static electricity. Refer "2.3.1
Discharging Twisted Pair Cable" (pg.35) for discharging method.
Straight cable
: Up to maximum 1000Mbps full duplex mode
: Up to maximum 1000Mbps full duplex mode
Twisted pair cable
crossing cable
optical cable
37
Chapter 2 Installation
Connecting the Equipment

Advertisement

Table of Contents
loading

Table of Contents