Installing Compact Flash Card - Fujitsu XG0224 Hardware Manual

XG0224 Hardware Guide
Connecting CX4 Cable
Firmly install CX4 cable to CX4 expansion card port and lock the cable.
Precautions
• Make sure to firmly insert the cable straight from behind.
• When bending the cable, make sure that the diameter of the bent cable does not become somaller than 10cm.
• When pulling out the cable, make sure to pull the pull tab of the cable connector. The cable may disconnect if you
pull the cable itself.
2.3.4

Installing Compact Flash Card

Compact Flash Card shall be installed in the power inlet side of the switch.
Caution
• Do NOT unplug during access. It may result in crashing setting data.
• Please refer to the following instructions, for installing the compact flash card. When installed
in a wrong direction, it may cause trouble to the switch.
Precautions
Make sure to use the specified product (SANDISK SDCFJ-256-388 256 MB).
1. Firmly insert and lock the Compact Flash Card to Compact Flash Card Slot on the power inlet side of
the switch.
Precautions
Please be careful of the direction when inserting Compact Flash Card.
CX4 Cable
40
Chapter 2 Installation
Connecting the Equipment