Brother CT-1200 Operation Manual page 12

MAINTENANCE INSTRUCTIONS
HOW TO CLEAN THE NET FILTER ASSEMBLY
1
Slide net filter assembly out of dirt compartment.
2
Wipe excess of dust from the filter.
3
Wash net filter assembly with water, using a soft sponge.
Allow net filter assembly to completely dry before replacing it, then
4
insert it into the dirt compartment.
CAUTION: Do not use chemicals, bleach or hot water to clean the dirt
compartment. Wash with water using a soft sponge. Do not dry with
hair dryer or heater.
HOW TO CLEAN THE MAIN FILTER
1
Release dirt compartment from the vacuum cleaner.
2
Pull out main filter case.
3
Remove main filter from the case and scrub the filter.
4
Wash the filter with soap and water.
Allow the filter to completely dry before putting back
5
in the filter case.
6
Replace the filter case into the dust body.
CAUTION: Do not use a washing machine for cleaning. Do not dry with hair dryer or
heater. Be sure the filter is set in the right position.
NOTE: For maximum performance we recommend to clean this filter every time you
empty the dirt compartment.
HOW TO CLEAN THE VALVE
The valve assembly, which selects suction for the
tools or floor mode, is located on the back of the
vacuum. If you detect an obstruction in the valve
while selecting the floor or tool mode, please clean
the valve assembly as follows:
1
Remove 4 screws.
2
Pull off the cover and valve assembly.
3
Clean the inside.
4
Set the cover and replace screws.
12
Dust Body
Main Filter case
Main Filter
Valve
Fig.27
Fig.28
To tools
Valve
T O O
L S
F L O
O R
Cover
To nozzle head
Cover
Fig.29