Installing The Controller Cache Battery Pack - HP 201723-B21 - StorageWorks Modular SAN Array 1000 Hard Drive Maintenance And Service Manual
Modular smart array
Hide thumbs
Also See for 201723-B21 - HP StorageWorks Modular SAN Array 1000 Hard Drive:
- Reference manual (48 pages) ,
- Administration manual (40 pages) ,
- Release note (13 pages)
Table of Contents
Advertisement
5.
Lift the pack upward to unhook the top of the battery pack.
6.
Wait approximately 15 seconds after removing the old battery to allow the battery charge monitor
to reset.
NOTE:
If you do not wait 15 seconds after removing the old battery, full charge of the new cache
battery is delayed.
7.
Repeat
step 3
Installing the controller cache battery pack
1.
Remove the array controller as instructed in
2.
Remove the controller cache module as instructed in
3.
Remove the controller cache battery pack as instructed in
4.
Hook the top of the new NiMH battery pack to the top of the module, with the pack held at a
30-degree angle to the plane of the module.
80
Customer replaceable components
15517
15518
through
step 6
to remove the second battery pack on this cache module.
15519
Removing the
controller.
Removing the controller cache
Removing the controller cache battery
module.
pack.
Advertisement
Table of Contents
