D-Link DCS-1000W Manual page 20

DCS-1000W's encryption code under either Infrastructure mode or Ad-hoc
mode.
The default setting for the Encryption Key is "Disable". Therefore, to secure
the wireless transmission be sure to Enable the Encryption Key by entering the
relevant data.
Note:
Carefully input the Encryption Code, any error setting the code will cause the
communication link to fail.
LED Control:
The LED control allows you to setup the LED illumination as desired. This
feature provides the flexibility when surveillance activity is ON.
There are three options as follows:
§
Normal
§
OFF
§
Dummy
The default setting for the LED control is "Normal". When you have
configured the LED control the correct illumination will set in after 1 minute.
Note:
This function is built-in to the LED indicators to add extra capabilities. The
three options allow the Administrator to configure and camouflage the
illumination for the LED indicator to falsify the monitoring status. In Normal
Mode the LED indicator functions normally. Under Off Mode the LED
indicators are both off, however, it is still monitoring the activity. In Dummy
Mode the LED indicators operate in monitoring condition but monitoring
activity is off or on.
Power - Steady On of the LED indicator.
LAN/WLAN - Steady On of the LED indicator. When
LAN/WLAN activity is present the LED indicator will flash
steadily.
Power - LED indicator is off
LAN/WLAN – LED indicator is off
Power - Steady On of the LED indicator.
LAN/WLAN -
flashing.
Steady On of the LED indicator with random
19