Table of Contents
Advertisement
2-2. Connecting Your Projector
Connect this unit and the projector as shown below. Connect the DVI-D A input terminal (DVI-A) on the projector and the DVI
OUT-A terminal on this unit, as well as the DVI-D B input terminal (DVI-B) on the projector and the DVI OUT-B terminal on this
unit using two commercially available DVI-D signal cables.
Alternatively, when a mode to control this unit from the projector (linked mode) is used, connect this unit with the projector using
a LAN cable.
LAN
LAN cross cable
(not supplied)
DVI OUT-B
DVI OUT-A
MM2000
DVI-D signal cable
(not supplied)
NC series projector
DVI-A
DVI-B
LAN
Touch panel controller (option)
2. Installation
11
Advertisement
Table of Contents
