Check The Location For Suitability; Lift And/Or Move Your Panel (The How To's) - Pioneer 141FD - PRO - 59.6" Elite KURO Plasma Panel Operating Instructions Manual

Install Your Flat Panel Display
02
2.2.1

Check the Location for Suitability

When choosing the location for your panel, there are several factors to keep in mind. The installation site should
be out of direct sunlight and have sufficient ventilation around the flat panel display to allow cooling. The diagram
below is an example of a stand-mounted panel with proper ventilation.
Use the checklist below to judge possible installation sites.
Sufficient ventilation
Safe from excessive vibrations
Away from air conditioners
Free of moisture or dampness
No danger of splashing water
Route cords and cables safely
For specific cautions and safety information, refer to "8.2 Physical Location & Temperature Considerations" and
"8.8 Safety Precautions."
2.2.2

Lift and/or Move Your Panel (the How To's)

This flat panel display is built for endurance but because of the technology, the panel must be handled with care.
Use the handles attached to the rear of the flat panel display to lift the unit. To avoid flexing or twisting the unit,
you need at least two people to lift and move the panel. Do not move the flat panel display by holding only a single
handle or by dragging the panel by its handles.
(PRO-141FD)
Note: Do not use the handles to hang the flat panel display or as anchors to prevent the panel from slipping or
tipping after it is mounted.
14
En
Over 50 cm
(19 11/16 inches)
Over
10 cm
(3 15/16
inches)
(PRO-101FD)
The distance behind and above the panel
changes depending on your choice of mount.
Consult with your dealer or professional
installer for proper ventilation.
No danger of power overloads
Separate from other IR equipment
Protected from hits or shocks
Distance from heat sources
Out of direct sunlight
Away from strong lighting sources