HP ap5000 - All-in-One Point of Sale System Hardware Reference Manual page 21

9. If you are replacing the VFD customer display, slide the new customer display into the slot on the
hinge (1) and insert the two screws that secure it in place (2).
Figure 2-16
10. Attach the hinge bracket cover by placing the upper sides of the cover over the sides of the bracket
(1) then pressing the bottom of the cover onto the bracket so that it snaps in place (2).
Figure 2-17
11. Replace the bottom I/O cover (see
12. Reconnect the power cord and press the power button.
13. Configure the new customer display (refer to
on page
ENWW
Replacing the VFD Customer Display
Replacing the VFD Hinge Bracket Cover
27).
Replacing the Bottom I/O Cover on page
Configuring the MSR and VFD Customer Display
Removing and Replacing the VFD Customer Display
6).
15