HP ap5000 - All-in-One Point of Sale System Hardware Reference Manual page 26

7. Lift the power supply and its cables out of the base of the unit.
Figure 2-23
8. Connect the external power cord to the power supply.
9. Route the circular end of the power cord through the hole at the top of the base and connect the
power cord to the power connector on the bottom I/O panel.
10. Place the power supply into the base so that it is sitting on the metal tabs inside the base.
Figure 2-24
20 Chapter 2 Hardware Upgrades
Removing the Power Supply
Replacing the Power Supply
ENWW