HP ap5000 - All-in-One Point of Sale System Hardware Reference Manual page 32

16. Replace the five screws that secure the display head to the housing.
NOTE:
included.
Figure 2-31
17. Connect the MSR cable (1), place the MSR onto the side of the display head (2), and replace the
two screws that hold the MSR in place (3).
Figure 2-32
18. Turn the unit over and onto its base.
19. Plug the power cord and all peripherals into the bottom I/O panel.
20. Replace the bottom I/O cover (see
21. Replace the drive cover (see
22. Plug in any peripherals that were unplugged from the side I/O panel.
23. Plug the power cord into an electrical outlet and press the power button.
26 Chapter 2 Hardware Upgrades
Some models may have only four screws. The center screw shown below may not be
Replacing the Display Head
Replacing the MSR
Replacing the Drive Cover on page
Replacing the Bottom I/O Cover on page 6).
8).
ENWW