Configuration; Configure Your Adapter - D-Link DGE-560T - Gigabit PCI-Express SNMP VLAN Flow Control Network Adapter User Manual

Configure your Adapter

After you install your new D-Link adapter, by default, the TCP/IP settings should be set to obtain an IP address from a DHCP server (i.e
router) automatically. To verify your IP address, please see follow the steps below:
Windows 2000/XP: Click on Start > Run. In the run box type cmd and click OK.
®
Windows Vista : Click on Start > All.Programs > Accessories > Command.Prompt.
™
At the prompt, type ipconfig and press Enter.
This will display the IP address, subnet mask, and the default gateway of your adapter.
If the address is 0.0.0.0, check your adapter installation, security settings, and the settings on your router. Some firewall software programs
may block a DHCP request on newly installed adapters.
D-Link DGE-560T User Manual