Table of Contents
Advertisement
Using the Remote Control
Once your device codes are entered, you are ready to start using your universal remote control.
The device keys allow you to switch from one device to another. Some keys behave in a special
way—they control one device while you are actually in another device mode. For instance, while
in SAT (satellite) mode, pressing Volume +/- controls your TV's volume—not the DST-3000
receiver's volume. This is because the remote control knows that there is no volume control on
the DST-3000 receiver.
Advanced feature keys (i.e.,
DST-3000 receiver. For other devices, only the primary keys (
For Sony-brand devices, use the
For RCA-brand devices, the device key ("TV" or "VCR") may function as the "power on" key
and
the "power off" key.
POWER
Switching the Remote Control to Operate Additional DST-3000
Receivers
Your remote control can be reprogrammed to operate additional DST-3000 receivers. This may
be necessary in situations where multiple DST-3000 receivers are located in the same general
area and can pick up signals intended for one specific receiver.
To switch the remote control, simply press and hold the
ID. The receiver ID can be 001 through 008. Do not forget the two zeros. Remember to access the
ADVANCED PREFERENCES screen using the keys on the front of the DST-3000 receiver to
pair it with the remote control.
The other way to program your remote control to match your DST-3000 receiver is to scan for the
correct code.
1) Keep your remote control aimed at the device you want to control during this process.
The remote control will send out the "power" command for the DST-3000 receiver.
2) While holding down the SAT key, press the MUTE key for one full second. Then release
the keys. The SAT key should light and stay lit (indicating programming mode). If it
doesn't, repeat the process.
3) Once you are in programming mode, repeatedly tap the
codes, sending out the power command, which could take up to eight presses. When your
DST-3000 receiver shuts off, you have found the code.
4) Press the
POWER
code, press the SAT key again.
The remote will remember the code until you reprogram it.
Identifying Codes That Have Been Stored
You can identify the codes you stored in your remote control's device keys. These codes can be
used when programming additional remote controls.
1) While holding down the device key, press the MUTE key. Then release both keys.
2) Press the
ACTION
Each digit of the three-digit code is separated by a two-second period the light is off. For
example, if the code number is 021, the light will blink 10 times (for "0"), pause two
seconds, blink two times (for "2"), pause two seconds, and then blink one time (for "1").
Page 8-8
Toshiba DST-3000 High Definition Digital Receiver
,
) are not supported for devices other than your
ACTION
EXIT
key as the "Enter" key.
SELECT
key to verify that you haven't missed the code. In order to lock in the
key and count the number of times the red light in the device key blinks.
,
, and
) will function.
POWER
key while entering the receiver
SAT
key to step through the
Advertisement
Table of Contents
