Connecting The Vcr Control Cable; Finding The Vcr's Remote Control Sensor; Now You Can Turn It On - Toshiba DST-3000 Owner's Manual

Connecting the VCR Control Cable

With the proper connections the DST-3000 receiver can control your VCR
for unattended recording.
Note: The output of the HD receiver must be in SD mode
to record using the connection configurations previously
described in this chapter.

Finding the VCR's Remote Control Sensor

Plug the VCR control cable into the back of the DST-3000 receiver.
So that the DST-3000 receiver can control your
VCR, the emitter end of the VCR control cable must
be attached where the VCR's remote control sensor
is located. This is labeled on some VCRs. You may
also find a diagram in your VCR manual indicating
the sensor position. It is commonly identifiable by a
small dark plastic window. For reference, see the
sensor on the DST-3000 receiver located in the
center.
If the sensor is not labeled or documented, you will
need to scan the front of your VCR with your VCR
remote control. Use the following procedure to
accomplish this:
Hold the VCR remote control about ½-inch
G
from the front left side of your VCR.
Slowly move the remote control to the right repeatedly pressing the remote control's
G
key on and off.
POWER
Once the VCR responds to pressing the
G
tion of the remote control. This should indicate the location of the VCR remote control
sensor.
Once the sensor position has been determined, temporarily attach the emitter to the area with a
piece of tape until the system can be tested. Refer to the "VCR Setup" subsection in Chapter 7,
"DST-3000 Receiver's Menu System," to program and test the VCR control feature.
Upon verifying that the VCR control is functioning properly, you can remove the tape and
permanently attach the emitter using the peel-and-stick backing. This attachment should not
interfere with normal VCR operation.

Now You Can Turn It On

Once you have connected everything, you can begin powering up the components. Turn the TV
on and set it to the HD input, VIDEO or S-VIDEO, or the DST-3000 receiver's output channel (3
or 4). Do the same for the VCR, if applicable. Now turn the DST-3000 receiver on. You will see
the start-up screen for several seconds.
Page 2-14
Toshiba DST-3000 High Definition Digital Receiver
POWER
The VCR Control
Look for indications of the remote control
sensor
Scanning for the remote control sensor
key on the remote control, note the posi-
cable and jack