INSTALLING THE RECEIVER
Follow steps A to C below. Your receiver will be ready to display digital programs on your
TV.
STEP A: CONNECTIONS
DO NOT PLUG THE RECEIVER INTO THE MAINS YET.
Before you use this receiver, it is necessary to connect it to your TV.
1. CONNECTING TO TV
Connection to Antenna
1-1.
Disconnect the antenna cable from your TV and connect it to the "ANT.IN" terminal on the back of
the receiver.
"RF OUT" Connection to TV or VCR
1-2.
This "RF OUT" provides you a RF loop-through function to receive analogue TV programs as well as
digital programs. Use an RF coaxial cable (not supplied) to connect the HD-S25 "RF OUT" terminal to
TV's or VCR's antenna input.
Before connecting or disconnecting the antenna cable, turn off the receiver and
antenna booster, if any.
To TV antenna input
Connections to TV – Video Connection
1-3.
In the accessory box, you will find two sets of cables: One is the component video cable (with red, green
and blue connectors) and the other is the Audio/Video cable (with yellow, white and red connectors).
For better video quality, we recommend that you use the Mini D-Sub 15-pin cable or the RGBHV video
cable (with 5 RCA connectors). Both of these cables are not included in the HD-S25 package.
You have 5 choices for connecting the video output from the receiver to your TV. Use only one of the
following connections (with (a) or (b) being the best choice):
Mini D-Sub 15-pin connection: If your TV has a RGB Mini D-Sub 15-pin video input
(a)
12
HD-S25
AUX INPUT
Y
P
B
P
R
RF coaxial cable
(not supplied)
Antenna cable
(not supplied)
ANT. IN
L
R
RF OUT