V.FORMAT (Video Format)
The "V.FORMAT" button on the remote control is used to change the video format setting among "PAL"
(for MODE-Switch being set to YP
x
st
1
button press displays the current video format
x
Next press (within 5 seconds) sets the video format to the next format.
PAL
AUTO
576p
AUTO
Note: For correct video format setting, please refer to System Setup Table on page 50.
A.RATIO (Aspect Ratio)
x
Press the "A.RATIO" button on the remote control to show current aspect ratio.
x
Within 5 seconds, pressing the "A.RATIO" button again will change the aspect ratio. Keep pressing
this button will adjust the aspect ratio among "Pillarbox", "Letterbox" and "Crop".
x
The recommended settings are shown in the table below:
If you are watching a 4:3 program
Please use "4:3 (16:9 Crop)". If this setting is
selected and your program is in 16:9, both sides of
the picture will be cut off to fill your 4:3 TV.
Please use "16:9 (4:3 Pillarbox)". This setting
allows you to display a 4:3 program on a 16:9 TV
screen in pillarbox (with masking bars on both
sides of the picture).
Note: If, for purposes other than personal viewing, you display a program in an aspect ratio different
from its original setting, you may infringe on the copyrights that the program may be under.
42
P
only), "AUTO", "1080i", "720p", and "576p".
B
R
1080i
720p
1080i
720p
(MODE-Switch is set to RGB)
576p
(MODE-Switch is set to YP
If you are watching a 16:9 program
Please use "4:3 (16:9 Letterbox)". This setting
allows you to display a 16:9 program on a 4:3 TV
screen in letterbox (with masking bars above and
below the picture).
Please use "16:9 (4:3 Pillarbox)". This is the
default aspect ratio setting for Australia .
P
)
B
R