Toshiba HD-S25 Owner's Manual page 49

Phenomenon
(9) Not all channels are available
after using "QUICK SCAN"
(10) Cannot lock signal by using
"MANUAL SETUP"
(11) No Teletext / Closed Caption
(12) No picture when the receiver is
set to "AUX" mode
(14) Cannot receive channels after
moving the receiver between
cities (for instance from
Melbourne to Sydney)
(15) The remote control does not
work properly
(16) "MENU" button is pressed but
no menu is shown on the
screen
On Screen Message
Message
(1) Bad Signal
(2) Database is Empty
(3) Incorrect Password
(4) Non Support HD Format
(5) Program is Locked by Guard
Rate
(6) Program is Under Guard
(7) Program Rate is over Guard Rate
[xxx]
(8) Weak Signal
(a) Try "AUTO SCAN" to scan all the channels.
(b) If you still cannot get some channels please use "MANUAL
SETUP" to scan them one by one.
(a) Check the frequency that you entered is exactly the centre
frequency of the wanted channel.
(b) Please refer to solutions in Phenomenon (3) above.
Make sure the channel that you are watching carries Teletext /
Closed Caption information from I-PLATE.
(a) Make sure your TV's HD input supports your DVD output
mode.
(b) Make sure the MODE-Switch is set to YP
(c) Check the receiver's connection to DVD player (page 16).
(d) Check the receiver's connection to TV (refer to YP
connection on page 14).
(e) Check the video cable(s) are correctly and firmly connected.
Please refer to page 27 to reset data.
(a) Point the remote control at the remote sensor of the receiver.
(b) Operate the remote control within about 5m.
(c) Replace the batteries with new ones.
(a) If you connect the receiver using COMPOSITE output, use
the "V.FORMAT" on the remote control or on the front panel to
switch the video format to "PAL" (for MODE-Switch being set
to YP P only).
B R
(b) Make sure the connection between the receiver and TV
matches the mode your TV should be set to. For instance, if
you use a RCA cable you may choose external video input
mode in TV.
(c) Check the brightness level of your TV.
(d) Refer to page 50 system setup table and check STB system
set-up.
(a) Check the antenna is connected correctly and firmly to the
tuner input (ANT.IN) of the receiver.
(b) Refer to solutions for Phenomenon (3) on page 48.
No channel data available in the box.
Please refer to page 25 for reinstallation.
Please input the correct password.
The HDTV digital channel cannot be shown on the small PIP
window.
Please input the correct password or change parental-rate (see
page 34) to view the program.
Please input the correct password or change lock setting in menu
to view the program.
Please input the correct password or change parental-rate (see
page 34) to view the program.
Make sure antenna or signal input cable is connected correctly.
Solution
P mode
B R
Solution
P
B R
49