HP Integrity rx1600 Deployment Manual page 61

Table 6-7 Custom Script File Options (continued)
Option
Size
Sectors
StripeSize
ArrayAccelerator
ResourceVolumeOwner
Value
Specifies the size of the logical drive. If the logical drive is new, the size is for
the new logical drive. In Reconfigure mode, if the logical drive already exists
and the size is different than the existing size of the logical drive, the cpqacuxe
utility attempts to extend the logical drive to the new size. This option is not
required. If the size is not specified for a new logical drive, the default is MAX.
If the size is not specified for an existing logical drive, the current logical drive
size remains unchanged.
• [N]: The size in MB.
• MAX: Uses the maximum size possible for the logical drive.
Specifies the Max Boot setting (Sectors Per Track) for the logical drive. The
Sectors option is not required. If the logical drive is new, the default is 32. If the
logical drive already exists, then the default is the current Sectors setting on the
logical drive.
• 32: Disable Max Boot (32 sectors per track).
• 63: Enable Max Boot (63 sectors per track).
Specifies the Stripe Size for the logical drive in KB. In Configure mode, the Stripe
Size is the Stripe Size for the new logical drive. In Reconfigure mode, if the
logical drive already exists and the Stripe Size is different than the existing Stripe
Size on the logical drive, the cpqacuxe utility attempts to migrate the logical
drive to the specified Stripe Size. The Stripe Size option is not required. If the
Stripe Size is not specified for a new logical drive, the Stripe Size is the default
Stripe Size for the RAID level of the logical drive. If the Stripe Size is not specified
for an existing logical drive in Reconfigure mode and the user is not migrating
the RAID, then the current Stripe Size setting remains unchanged.
The following Stripe Size values are available:
• 8: 8 KB
• 16: 16 KB
• 32: 32 KB
• 64: 64 KB
• 256: 256 KB
• 16: 16 KB
The following Stripe Size values are available for RAIDS):
• RAID 0: 8, 16, 32, 64, 128, 256 (default is 128)
• RAID 1: 8, 16, 32, 64, 128, 256 (default is 128)
• RAID 4: 8, 16, 32, 64 (default is 16)
• RAID 5: 8, 16, 32, 64 (default is 16)
• RAID ADG: 8, 16, 32, 64 (default is 16)
Specifies the Array Accelerator setting for the logical drive.
• Enable: Enables the Array Accelerator for the logical drive. This is the default
setting for new logical drives.
• Disable: Disables the Array Accelerator for the logical drive.
Specifies that this logical drive should be a snapshot resource volume and
specifies the owner logical drive ID. If this command is not specified, the logical
drive is a normal data volume.
N: This value is the logical drive ID of an existing logical drive which owns this
snapshot resource volume.
cpqacuxe 61