HP Integrity rx1600 Deployment Manual page 65

Table 6-8 Error Codes (continued)
Code Error
2837
New Logical Drive ID already
exists
2838
Cannot create Logical Drive
2839
Cannot migrate Logical Drive
Raid
2840
Cannot migrate Logical Drive
Stripe Size
2841
Cannot extend Logical Drive
2842
Invalid Raid
2843
Invalid Size
2844
Invalid Stripe Size
2846
Cannot change Logical Drive
Sectors
2845
Invalid Sectors
2848
Cannot change Logical Drive
Array Accelerator Setting
2847
Invalid Array Accelerator
Setting
290
Error communicating with
Controller
278-282,
Controller is locked by another
2564
machine or user
268
Error saving Controller
1065-1066
Too many coinciding expansion,
migration, or extension
operations
1110
Controller does not support
license keys
1093
Controller requires physical
drives to set license keys
Reason
When running in Configure mode, this error occurs when
the Logical Drive ID in the script file already exists in the
configuration. Configure mode can only create new logical
drives.
The controller does not allow a new logical drive to be
created. This could be because there is no free space on the
array, or the maximum number of logical drives has already
been reached.
The controller does not support migration, or the current
configuration of the controller does not allow migration to
occur.
The controller does not support migration, or the current
configuration of the controller does not allow migration to
occur.
The controller does not support extension, or the current
configuration of the controller does not allow extension to
occur. For example, there might be no free space on an array,
so extension is not supported for the logical drive.
The specified RAID is invalid or is not possible with the
current configuration.
The specified size is invalid or is not possible with the current
configuration.
The specified stripe size is invalid, is not supported with the
current RAID level, or is not supported with the current
configuration.
You cannot change the max boot on a configured logical
drive. This leads to data loss.
The specified Max Boot setting is invalid, or is not supported
with the current configuration.
The current controller configuration does not support
changing the logical drive Array Accelerator state.
The specified Array Accelerator setting is invalid or is not
supported with the current configuration.
There was a problem communicating with one or more
controllers.
One or more controllers is locked by another machine or user.
There was a problem saving one or more controller
configurations.
This error is the "invalid increase/decrease" in logical drive
offset error. This can happen when too many unsaved
expansions, extensions, or migrations are tried at the same
time.
The controller does not support license key entry or deletion.
The controller requires physical drives for license keys.
cpqacuxe 65