Panasonic 30 - Toughbook - Core 2 Duo Service Manual page 32

■ Assembly of LCD Back Damper (Application Model : Digitizer Model)
PCB
■ Assembly of Inverter PCB
Inverter Case Bottom
Important Parts
for Safety
Inverter
Remove the Release Paper,
and then attach the Inverter.
Set the Inverter Case Bottom to make it outside.
35mm
33
Attch to the side surface
of the Frame.
Match to the end of the
Frame within 0 to 0.5 mm
at the far side.
Screw the Board together
0 0.5mm
0 0.5mm
Do not press the
piezoelectric transformer.
Inverter MIL Cover
MIL Sheet
Wrap the Sheet to
overlap it on the side.
0 0.5mm
Remove the Release Paper on
the back side and attach it.
LCD Back Dumper
Lengthwise : Match to the LCD Frame.
Crosswise : Match to the middle line.
Digitizer PCB Ass'y
0 0.5mm
0 0.5mm
Insert it as the protrusion of
the Inverter Case Upper come
Insert from the direction
to the gap side of INverter MIl Cover.
of hole and notch.
2 4mm
32 / 90
Ensure the connector
10 2mm
is connected securely.
0 0.5mm
0 0.5mm
Confirm the direction of the
Inverter board when attaching.