Brother HL 1240 - B/W Laser Printer Service Manual page 153

P-2 Unable to print full pages of a document with the "PRINT OVERRUN" message.
User Check
(1) Press the panel button to print the data remaining in the printer.
(2) If this does not clear the error, reduce the complexity of your document or reduce the printer
resolution.
(3) Expand the printer memory by adding a commercially available SIMM. (HL-1250 only)
(4) Change the following setting in the printer driver and try again. The best combination of settings
below will vary depending on your document. (HL-1250 only)
Graphic Mode / TrueType
NOTE:
This problem may appear if the data is too complex. If it is not cleared by taking the actions
above, it will be impossible to print such data under the printer specifications.
P-3 Unable to print full pages of a document with the "MEMORY FULL" message.
User Check
(1) Press the panel button to print the data remaining in the printer.
(2) Reduce the complexity of your document or reduce the printer resolution.
(3) Expand the printer memory by adding a commercially available SIMM. (HL-1250 only)
NOTE:
This problem may appear if the data is too complex.
For the HL-1240 printer, if it is not cleared by taking the actions above, it will be impossible to
print such data under the printer specifications.
For the HL-1250 printer, take the following procedures.
<For HL-1250 only>
Possible cause Step
Unable to 1
recognize SIMM
SIMM / main 2
PCB failure
TM
mode / Use Printer TrueType
Check
Check the memory size in Print
Configuration. Is it the default
size?
Try installing SIMM into
another printer, then check the
memory size in Print
Configuration.
Is it possible to print the data?
6-43
CHAPTER 6 TROUBLESHOOTING
TM
Fonts.
Result Remedy
Yes Expand the memory size by
adding SIMM.
If the memory is already at the
maximum size, it will be
impossible to print the data
under the printer
specifications.
Yes Replace the SIMM.
No Replace the main PCB.