HP 6400/8400 User Manual page 102

Table 21 Error Messages (continued)
Status Code Value
91
Redundancy Mirrored Inoperative
92
Duplicate LUN
93
Other remote controller failed
94
Unknown remote Vdisk
95
Unknown remote DR group
96
PLDMC failed
97
Storage system could not be
locked. System busy. Try
command again.
98
Error on remote storage system.
99
The DR operation can only be
completed when the
source-destination connection is
down. If you are doing a
destination DR deletion, make
sure the connection link to the
source DR system is down or do
a failover operation to make this
system the source.
100
Login required - password
changed.
102 Error messages
Meaning
The disk group is in a redundancy mirrored
inoperative state and the request cannot be
completed.
The LUN number is already in use by
another client of the storage system.
While the request was being performed, the
remote storage system controller failed.
The remote storage system specified does
not exist.
The remote Continuous Access group
specified does not exist.
The disk metadata was unable to be
updated.
Another process has already taken the SCMI
lock on the storage system.
While the request was being performed, an
error occurred on the remote storage system.
The request failed because the operation
cannot be performed on a Continuous
Access connection that is up.
The management software is unable to log
into the device as the password has
changed.
How to Correct
Report the error to product support.
Select another LUN number and retry
the request.
Resolve the condition and retry the
request. Report the error to product
support.
Correctly select the remote storage
system and retry the request.
Correctly select the remote Continuous
Access group retry the request.
Resolve the condition and retry the
request. Report the error to product
support.
Retry the request later.
'Resolve the condition and retry the
request
Resolve the condition and retry the
request.
The storage system password may
have been re-configured or removed.
The management software must be
used to set the password up to match
the device so communication can
proceed.