HP 6400/8400 User Manual page 95

Table 21 Error Messages (continued)
Status Code Value
12
Invalid Parameter handle
13
Invalid Parameter Id
14
Invalid Quorum Configuration
15
Invalid Target Handle
16
Invalid Target Id
17
Invalid Time
18
Media is Inaccessible
19
No Fibre Channel Port
20
No Image
21
No Permission
22
Storage system not initialized
23
Not a Loop Port
24
Not a Participating Controller
Meaning
The supplied handle is invalid. This can
indicate a user error, program error, or a
storage cell in an uninitialized state.
In the following cases, the storage cell is in
an uninitialized state, but no action is
required:
Storage cell discard (informational
message):
Storage cell look up object count
(informational message):
Storage cell look up object (informational
message):
The supplied identifier is invalid. This can
indicate a user or program error.
Quorum disks from multiple storage systems
are present.
The supplied target handle is invalid. This
can indicate a user or program error (Case
1),
or
Volume set requested usage (Case 2):
The operation could not be completed
because the disk has never belonged to a
disk group and therefore cannot be added
to a disk group.
The supplied target identifier is invalid. This
can indicate a user or program error.
The time value specified is invalid. This can
indicate a user or program error.
The operation could not be completed
because one or more of the disk media was
inaccessible.
The Fibre Channel port specified is not valid.
This can indicate a user or program error.
There is no firmware image stored for the
specified image number.
The disk device is not in a state to allow the
specified operation.
The operation requires a storage cell to exist.
The Fibre Channel port specified is either
not a loop port or is invalid. This can
indicate a user or program error.
The controller must be participating in the
storage cell to perform the operation.
How to Correct
In the following cases, the message
can occur because the operation is
not allowed when the storage cell is
in an uninitialized state. If you see
these messages, initialize the storage
cell and retry the operation.
Storage cell set device addition policy
Storage cell set name
Storage cell set time
Storage cell set volume replacement
delay
Storage cell free command lock
Storage cell set console lun id
Report the error to product support.
Report the error to product support.
Case 1: Report the error to product
support.
Case 2: To add additional capacity
to the disk group, use the management
software to add disks by count or
capacity.
Report the error to product support.
Report the error to product support.
Report the error to product support.
Report the error to product support.
Report the error to product support.
The disk device must be in either
maintenance mode or in a reserved
state for the specified operation to
proceed.
Create a storage cell and retry the
operation.
Report the error to product support.
Verify that the controller is a
participating member of the storage
cell.
95