Cf_Terminal Command; Cf_Standbymode Command; Cf_P-Mane Command; Cf_P-Manetime Command - Sanyo PDG-DXL2000 - 2000 Lumens Specifications

PDG-DXL2000 Expand Serial Command Functional Specifications

8.10.16 CF_TERMINAL Command

Command "CF_TERMINAL_%1"[CR]
"COMPUTER" ----------------Set Input mode
%1
"MONITOR" ------------------- Set Monitor Out mode
Set Terminal setup. This command is available in normal Power ON status.
Details
Terminal means Computer 2 in this model.
Acceptable
Response
Unacceptable

8.10.17 CF_STANDBYMODE Command

Command "CF_STANDBYMODE_%1"[CR]
"ECO" ---------------------- Less standby electricity
%1
"NORMAL" --------------- Normal standby electricity
Switch Standby Mode setting.
Details
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable

8.10.18 CF_P-MANE Command

Command "CF_Pÿ MANE_%1"[CR]
"OFF" --------------------------------- Set Power Management to OFF
"READY" ----------------------------- Set Power Management to Ready
"SHUTDOWN" --------------------- Set Power Management to Shut Down mode
%1
"UP" ------------------------------ The same operation as pressing Up key or Left key
"DN" ------------------------------The same operation as pressing Down key or Right
Set/Cancel Power Management
The status set by this command is stored in EEPROM and its setting is effective
Details
after ALL is OFF
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable

8.10.19 CF_P-MANETIME Command

Command "CF_P-MANETIME_%1"[CR]
"01" ~ "30" ----------------------- Directly select setting time by the minute
"UP" ------------------------------- Plus one minute (01 → 02 → ÿ e ÿ e ÿ e → 30 → 01)
ÿ ÿ
"DN" ------------------------------- Minus one minute(30 → 29 → ÿ e ÿ e ÿ e → 01 → 30)
Set Power Management time
The status set by this command is stored in EEPROM and its setting is effective
Details
after ALL is OFF
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
"000"[CR]
"Error Code"[CR]
When Input is Computer 2, the projector returns "101" and the
command is not executed.
"000"[CR]
"Error Code"[CR]
key
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
39/72