Cf_Fanmode Command; Cf_Fancontrol Command; Cf_Filtimer Command; Cf_Filh Command - Sanyo PDG-DXL2000 - 2000 Lumens Specifications

PDG-DXL2000 Expand Serial Command Functional Specifications

8.10.26 CF_FANMODE Command

Command "CF_FANMODE_%1"[CR]
"L1" ---------------------------- Set Fan Mode to L1
%1
"L2" ---------------------------- Set Fan Mode to L2
Switch Fan Mode
When L1 is selected, fan noise after POWER OFF is louder.
When L2 is selected, fan noise after POWER OFF becomes quiet.
Details However fan rotates longer than L1.
The status set by this command is stored in EEPROM and its setting is effective
even after ALL is OFF.
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable

8.10.27 CF_FANCONTROL Command

Command "CF_FANCONTROL_%1"[CR]
"OFF" ---------------------------- Set Fan control to Off
%1 "ON1" ---------------------------- Set Fan control to On1
"ON2" ---------------------------- Set Fan control to On2
Set Fan control setting.
The status set by this command is stored in EEPROM and its setting is effective
Details
even after ALL is OFF.
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable

8.10.28 CF_FILTIMER Command

Command "CF_FILTIMER_%1"[CR]
"2000" -------------------- Set 2000 hours
"3000" -------------------- Set 3000 hours
"4000" -------------------- Set 4000 hours
%1
"OFF" --------------------- No warning display
"UP" --------------------- The same operation as pressing Up key or Left key
"DN" ---------------------The same operation as pressing Down key or Right key
Details Set timer of Filter warning display.
Acceptable
Response
Unacceptable

8.10.29 CF_FILH Command

Command "CF_FILH_%1"[CR]
%1 "RST" ---------------Reset Filter used time
Details Reset filter used time
Acceptable
Response
Unacceptable
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
42/72