Part Names and Functions
Remote Control Battery Installation
Open the battery
1
compartment lid.
Press the lid
downward and slide it.
To ensure safe operation, please observe the following precautions :
● Use two (2) AAA or LR03 type alkaline batteries.
● Always replace batteries in sets.
● Do not use a new battery with a used battery.
● Avoid contact with water or liquid.
● Do not expose the remote control to moisture or heat.
● Do not drop the remote control.
● If the battery has leaked on the remote control, carefully wipe the case clean and install new batteries.
● Risk of an explosion if battery is replaced by an incorrect type.
● Dispose of used batteries according to the instructions.
Remote Control Operating Range
Point the remote control toward the projector (Infrared
Remote Receiver) when pressing the buttons. Maximum
operating range for the remote control is about 16.4'(5 m)
and 60 degrees in front of the projector.
Adjustable Feet
Projection angle can be adjusted up to 8.9 degrees with the
adjustable feet.
Lift the front of the projector and pull the feet lock latches on
both side of the projector upward.
Release the feet lock latches to lock the adjustable feet and
rotate the adjustable feet to a proper height, and tilt.
Keystone distortion can be adjusted automatically with the
Auto setup function or manually by using the remote control
or the menu operation (see pages 26, 47-48).
16
Install new batteries
into the compartment.
Two AAA size
batteries
For correct polarity
(+ and –), be sure
battery terminals are
in contact with pins in
compartment.
Replace the
compartment lid.
30°
30°
Remote control
Adjustable Feet
16.4'
(5 m)
Feet Lock Latches