8.1
Cleaning the ScanSnap Exterior
Cleaning Materials
Cleaner F1
Cleaning Wipe
Lint-free dry cloth
ATTENTION
Note 1: To purchase cleaning materials, contact the FUJITSU scanner dealer where you purchased
the ScanSnap.
Note 2: Pre-moistened with Cleaner F1, Cleaning Wipes are used instead of moistened cloths.
Note 3: Any lint-free cloth can be used.
174
Parts No.
PA03950-0352
PA03950-0419
Commercially available (*3)
•
Never use paint thinner or other organic solvents.
•
During the cleaning, prevent water or moisture from getting inside the
ScanSnap.
•
Do not use aerosol sprays to clean the ScanSnap. Aerosol sprays cause dirt
and dust to enter the ScanSnap, resulting in ScanSnap failure and
malfunction, or errors in scanned images.
•
It may take long before the cleaner vaporizes if a large quantity is used. When
cleaning the ScanSnap parts, dampen a cloth with modest quantities of the
cleaner. In addition, wipe off the cleaner completely with a soft lint-free cloth to
leave no residue on the surface of the cleaned parts.
Remarks
1 bottle (100ml)
(*1)
1 pack (24 sheets)
(*1) (*2)
Cloth
Cleaner F1 or
neutral detergent
Paint thinner