Kenwood KRF-V6200D Instruction Manual page 42

Troubleshooting
Remote control unit
Symptom
Remote control operation is not possible.
USB message list
If the massages listed below appear on the display, playback of the connected USB device is impossible. Try a different USB device, or re-
record the contents in the USB device and try it again.
Display
"<NO SUPPORT> DEVICE"
"<NO SUPPORT> PROTOCOL"
"<NO SUPPORT> FILE SYSTEM"
"<NO SUPPORT> SIZE"
"NO FILE"
"NO PLAY"
"NO TITLE"
"ERROR 1"
"ERROR 2"
"ERROR 3"
42
English
Cause
The remote control is set to the DVD player operation
mode.
Batteries are exhausted.
The remote control unit is too far away from the main
system, controlling angle is too large, or there is an
obstacle between this unit and the remote.
The remote control has not been changed to the operation
mode for the Kenwood DVD player you wish to control.
The unit does not support the device connected to the USB jack.
The information from the USB device is not correct.
Unsupported protocol is used.
The file system is not a supportable one.
The size of the memory is too small.
There is no playable file.
Incorrect data is recorded.
The file is protected by DRM (digital rights management).
The file is broken.
The size of the file is too big or too small.
No tag information.
The tag is unreadable.
Communication error between the unit and the USB device.
The file system is broken.
Something wrong with the file.
Remedy
Press any of the Input Source keys to select the
appropriate operation mode.
Replace with new batteries.
Operate the remote control unit within the controllable
range.
Press the [CD/DVD] or [DVD/6CH] key to activate the
operation mode for the component you want to control
before operation.
Cause
7