Automatic Redial; End A Call; Receive A Call; Call In Absence Indicator - Motorola 4500 Manual

Basic Operation
Unsuccessful Call Attempts
If you hear one of the following signals, you have
not successfully completed your call.
Tone Description
Tone
Cellular System Busy
Fast Busy
Press S again before ending the
(reorder
unsuccessful call attempt to
signal)
automatically redial the call (see
System
"Automatic Redial", below), or press
Busy
E and dial the call again.
Cellular System Could Not
Alternating
Complete the Call
High/Low
You may have tried to place a call
Tone
before the
(intercept)
ON/LOCK
let you know your phone was fully
No
operative. Either press S again to
Service
redial, or press E and dial the call
again.
Slow Busy
Called Party's Line is Busy
Signal

Automatic Redial

Your telephone includes a convenient feature
designed to make repetitive call attempts when a
cellular system is busy.
If you receive an alternating high/low signal
(intercept) or the fast busy tone (reorder signal)
followed by snd to redial in the display when
attempting to place a call and wish to retry the
call, press S before ending the unsuccessful call
attempt. Redial is then displayed.
Your telephone will make the call attempt
continuously over the next four minutes. If four
18
indicator was lit to
minutes is insufficient time, press S to begin
another cycle. If the call attempt is successful, the
phone will ring to alert you of the connection.You
may terminate Automatic Redial by turning off the
phone or by pressing E.
NOTE Automatic Redial applies when the system
is busy and will not engage when the called
party's line is busy.

End a Call

Press E or return the handset to its mount.
The I I n n U U s s e e indicator will extinguish. If you have
activated the Automatic Hands Free feature, you
must press E to terminate the call.

Receive a Call

Lift the handset to your ear or press S if
an external microphone is present.
Power must be on to receive calls.

Call in Absence Indicator

If your phone is on and an incoming call is
unanswered, Call is displayed.
Press C or E to cancel the message and
clear the display.
In carry phone configuration, the display will go
blank after 6 seconds in order to conserve battery
energy.
Reactivate the display by pressing any key
except C, E, or P.
NOTE The phone will not display or retrieve the
phone number of the calling party.
Basic Operation
19