Brother DCP 585CW - Color Inkjet - All-in-One User Manual page 44

LCD messages when using the SES/WPS/AOSS control panel menu
LCD shows
Setting WLAN
Connecting SES
Connecting WPS
Connecting AOSS
Connected
Connection Failed
Incorrect Mode
i
Press .
®
(For Windows
You have completed the wireless network setup. If you would like to continue installing drivers
and software necessary for operating your device, please choose Install MFL-Pro Suite or
Initial Installation / Install MFL-Pro Suite from the CD-ROM menu.
(For Macintosh
You have completed the wireless network setup. If you would like to continue installing drivers
and software necessary for operating your device, please choose Start Here OSX from the
CD-ROM menu.
Configuring your machine for a wireless network (Not available for MFC-5490CN and MFC-5890CN)
Connection status
Searching or accessing the access point,
and downloading settings from the access
point.
Connecting to the access point.
Connection succeeded.
Connection failed.
(If this is shown after the LCD shows
Connecting SES, Connecting WPS or
Connecting AOSS.)
A session overlap was detected.
A session overlap was detected.
)
®
)
Action
—
—
—
1 Try starting from e again.
2 If the same message continues,
reset the machine back to the
factory settings and try again.
Check that only one router or access
point has SecureEasySetup™, the
Wi-Fi Protected Setup™ mode or
AOSS™ mode enabled and try starting
from e again.
3
34