Tools Required; Step 1-Preparing The Workstation - HP Xw6200 - Workstation - 2 GB RAM Installation Manual

Tools required

Round hole and square hole racks
●
T-15 Torx driver
●
Flat blade driver
Threaded hole racks
●
T-15 Torx driver
●
Flat blade driver
●
Cross-tip driver
For earlier HP racks including E3660B, E3661B, E3662B, J1450B, J1487A/B
●
T-15 Torx driver
●
T-25 Torx driver
●
M10 socket
●
Flat blade driver
Step 1—Preparing the workstation
1. Power down the workstation.
2. Disconnect the power cable and all other cables from the back of the workstation.
3. Remove the top cover by pushing a flat screw driver into slot 1 on the rear of the chassis, gently
pry the cover upward while pushing the top cover toward the rear of the workstation, and lift it off.
NOTE:
This enables you to get a better grip on the top cover and push it toward the rear. Be sure to the
replace access panel and front bezel after removing the top cover.
Figure 1
4 Sliding rack mount kit installation
If the top cover is difficult to remove, open the access panel and remove the front bezel.
Removing top cover
ENWW