HP Xw6200 - Workstation - 2 GB RAM Installation Manual page 5

For product-specific information, see the Service and Technical Reference Guide for your HP
workstation at http://www.hp.com/support/workstation_manuals.
Step 2—Installing rails and flanges
1. Align the left bracket with the screw holes on the left side (the bottom) of the chassis (1).
2. Use a Torx driver and two screws to attach the flange (2).
3. Align the inner slide with the two screw holes on the left side (the bottom) of the chassis (3).
NOTE:
4. Use a Torx driver and two screws to attach the slide (4).
5. Repeat this process for the right side (the top) of the chassis.
Figure 2
Step 3—Installing rails to the rack
(Optional) Adjusting slides to fit shallower or deeper non-HP racks
1. Remove the slide adjustment attachment (1).
2. Adjust the rail to the desired length (2).
ENWW
The front inner slide mounting hole is keyhole-shaped.
Installing rails and flanges
Step 2—Installing rails and flanges 5