HP Z400 - Workstation Installation Manual page 6

HP xw6000 Workstation series
1. Remove the front bezel from the workstation. See
2. Remove and discard the counter-sunk screw at the side of the DX115 case. This hole is used for
the shipping screw.
3. Install the DX115 case in the optical drive bay using the quick release system.
4. Install one (supplied) 6-32 x 1/4 in. screw (silver) for each DX115 unit for shipping support.
CAUTION:
drive system.
HP 600 and
1.
For HP
2.
For HP
connectors.
6 CRU Dataport DX115 kit installation
Failure to install the shipping screw might result in damage to the removable hard
800 Workstations
800 Workstations, remove the airflow guide to enable access to the optical bays.
800 Workstations, remove the card support to enable access to the system board
Figure 2 Removing the front bezel on page 4.
ENWW