HP Z400 - Workstation Installation Manual page 8

Removable media kit

Hide thumbs Also See for Z400 - Workstation:

Table of Contents

HP xw8000 and xw9000 Workstation series

Remove the front bezel from the workstation. See

Install the DX115 case in the optical drive bay using the quick release system.

Install one (supplied) M3 x 5mm screw (black) for each DX115 unit for shipping support.

CAUTION:

drive system.

Step 3—Installing a hard disk in the DX115 carrier

CAUTION:

Other procedures may result in system hangs, data loss, or even drive damage. The component

supplier's user guide describes a procedure for inserting or removing the carrier (with drive) while the

workstation is booted and then powering the drive via the power switch on the enclosure. Microsoft

Windows XP and Windows Vista do not support this action.

NOTE:

You do not have to remove the DX115 case from the workstation for this step.

Install your hard drive in the DX115 carrier. For detailed instructions, see the following:

●

The CRU Dataport DX115 User's Guide for SATA or SAS removable drive enclosures

●

The CRU Dataport website at

dx115.html

CRU Dataport DX115 kit installation

Failure to install the shipping screw might result in damage to the removable hard

Insert or remove the carrier (with a disk drive) only when the workstation is shut down.

http://www.cru-dataport.com/htmldocs/products/dataexpress/

Figure 2 Removing the front bezel on page

ENWW

Table of Contents